Last updated: 11/24/2009

Dermabrasion is commonly performed using a handheld engine that can reach rotational speeds of 18,000–35,000 rpm. Rapid planing of the skin is achieved through the combination of this rotational speed, the abrading attachment, and pressure...

applied by the operator. Because of the importance of the skill of the operator, patients should select doctors with significant experience with the procedure.

There are three types of abrading attachments in common use: diamond fraises, wire brushes, and serrated wheels. Diamond fraises are stainless steel wheels that have diamond chips of various coarseness bonded to its surface. Cylinder and pear-shaped diamond fraises are also used for work in various locations. The wire brush is a wheel with wires attached at various angles. In experienced hands, it is the most effective attachment for deep scars. The serrated wheel or diamond fraise is often used to soften the edges of skin removed with a wire brush.

Before the procedure begins, medication is often given to relax the patient and reduce pain. For small areas, local anaesthetic nerve blocks are often used to numb the area being treated. Alternatively, topical cryoanaesthesia (numbing the skin using cold) can be used. This is done by spraying a cold-inducing agent on the skin. Sometimes the skin is pre-chilled with ice to increase the anaesthetic effect.

During the procedure the patient lies on his back on the surgical table, eyes covered with disposable eye patches. The area being treated is parted with Gentaian violet, a stain that will help gauge how deep the treatment is going. A gloved and gowned assistant holds the skin taut while each section of the face is abraded using the hand-held engine. The surgeon works in sections to avoid obvious lines of demarcation in the final results. If the entire face is to be dermabraded, laser is commonly used for the lower eyelids and lip as less than satisfactory results often occur in these areas.